Nagios Support Forum

Ahoy folks,

Semi recently I attempted the upgrade from xi 5.6.x to 5.7.2 in my PROD ENV.
Naturally I performed the same upgrade in my TEST ENV and it went off fine.
However, the quantity of checks / scale of my PROD ENV is different than TEST.

To that end, I got bit by the ndo3 bug (reported also by a few others on these forums), where it acts very slowly, and fails to load the "Monitoring Engine Check Statistics" (and possibly other areas).
Via a support ticket, I understood there to be two main options:
1.) Stay at 5.7.x, but downgrade back to ndo2db (not a palatable state for our PROD ENV).
2.) Revert back to 5.6.x, and wait for xi 5.7.3 to be released (which was slated to have the ndo3 fix included).

Thus, I see xi 5.7.3 is released, but observe no mention of the ndo3 "fix" in the changelog (https://www.nagios.com/downloads/nagios-xi/change-log/).
Did the fix make it into this release, or is this still pending?

I would rather ask ahead of time, and save a lot of grief of checking to see mid-upgrade.

Thank you for your time,

Sorry about that, somehow the changes for NDO3 didn't get added to the page.

They are included and the page has been updated

Ahoy Scott,

Superb, and thank you!
Looks good, and do close this thread when a moment avails.

inversecow wrote:Ahoy Scott,

Superb, and thank you!
Looks good, and do close this thread when a moment avails.

Great!

Locking thread